How to Install CB Antenna on Jeep Wrangler? [Proven Guide]

CB radios are great for communication in remote areas. If you are taking your Jeep Wrangler deep into the woods, then installing one of these radios will help you immensely.

But you might not find instructions on how to do it since not many people use CB radios anymore. This is why we have prepared a step-by-step guide for you. We’ll talk about the installation process, and we hope you can follow them and get the CB radio cackling connections in no time!

So here we go, pay attention!

Here, we’ll tell you the step-by-step process so that you can easily install the CB antenna on your Jeep Wrangler. The steps have been kept simple so you encounter no issues while following them.

How to Install CB Antenna on Jeep Wrangler

Step 1: Pick Best CB Radio

The first thing you need to do is picking the best CB radio for Jeep out there. However, a CB radio for off roading will do as well. After picking the right CB radio, it’s time to make some space at the back of the Jeep, by removing the spare tire, for the CB antenna to be installed.

Step 2: Mount Antenna

Locate the two upper right bolts, remove them, and sandwich the antenna mount in between the tire carrier and the bolts.

Step 3: Connect Coax Cable

If you have a pair of antennas at hand, it would be best for the antenna and the coax cable to be attached through the antenna mount at this point.

Step 4: Feed Through The Coax Cable

Make sure to feed the coax cable through the grommet in the tailgate. At this point, remember to remove the plastic piece inside of the tailgate to expose the wires, so that they can be reached without any hassle.

Step 5: Tucking In Cable

At this point, you can start tucking the cable in, from around the back, and the edges of the car to all the way in the front. When you reach the front of the car, you have to place the end of the cable by relying on the intended placement of the CB Radio itself.

Step 6: Attach The Cable To The Radio

Once the CB Radio is mounted onto the designated spot, make sure to attach the cable to the back of the radio. Once that is done, both the radio and the antenna will be thoroughly functional.

FAQs

What is the first step in installing a CB antenna on a Jeep Wrangler?

The first step is to choose the best CB radio for your Jeep. Once you’ve selected, you’ll need to create space at the back of the Jeep by removing the spare tire. This is where the CB antenna will be installed.

How do I mount the antenna on my Jeep Wrangler?

To mount the antenna, locate the two upper right bolts, remove them, and sandwich the antenna mount between the tire carrier and the bolts.

How do I connect the coax cable to the antenna?

If you have a pair of antennas, it would be best to attach the antenna and the coax cable through the antenna mount at this point.

How do I feed the coax cable through the grommet in the tailgate?

You must remove the plastic piece inside the tailgate to expose the wires. This will allow you to feed the coax cable through the grommet in the tailgate without any hassle.

How do I attach the cable to the radio?

Attach the cable to the back of the radio once the CB Radio is mounted onto the designated spot. Once that is done, both the radio and the antenna will be thoroughly functional.

Conclusion

This whole process of installing the CB antenna should not take more than half an hour, especially if you are prepared to install the CB antenna with all the required parts at hand. This process also happens to be the easiest way of installing the antenna. Hence, everything should get set up in almost no time!

If you encounter any problem while installing the CB radio, let us know in the comments. Our team of experts will try to come up with a solution as soon as possible. Or you could main to us as well.

Best of luck to you!